ASTM A265.pdf

Designation: A 265 – 03

Standard Specification for

Nickel and Nickel-Base Alloy-Clad Steel Plate

1

This standard is issued under the fixed designation A 265; the number immediately following the designation indicates the year of

original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A

superscript epsilon (e) indicates an editorial change since the last revision or reapproval.

1. Scope

1.1 This specification

sion resistance of the alloy is of prime importance.

1.2 The values stated in inch-pound units are to be regarded

as the standard. SI units are provided for information only.

2. Referenced Documents

2.1 ASTM Standards:

A 6/A 6M Specification for General Requirements for

Rolled Structural Steel Bars, Plates, Shapes, and Sheet

Piling

3

A 20/A 20M Specification for General Requirements for

Flat-Rolled Stainless and Heat-Resisting Steel Plate,

Sheet, and Strip

A 578/A 578M Specification for Straight-Beam Ultrasonic

Examination of Plain and Clad Steel Plates for Special

Applications

A 751 Test Methods, Practices, and Terminology for

Chemical Analysis of Steel Products

(UNS NO6600, N06601, N06603, NO6690, N06025, and

N06045) and Nickel-Chromium-Cobalt-Molybdenum Al-

loy (UNS NO6617) Plate, Sheet, and Strip

5

B 333 Specification for Nickel-Molybdenum Alloy Plate,

Sheet, and Strip

5

B 409 Specification for Nickel-Iron-Chromium Alloy Plate,

Sheet, and Strip

5

and Strip

5

B 463 Specification for UNS NO8020, UNS NO8026, and

UNS NO8024 Alloy Plate, Sheet, and Strip

5

B 575 Specification for Low-Carbon Nickel-Molybdenum-

Chromium, Low-Carbon Nickel-Chromium- Molybde-

num, Low-Carbon Nickel-Chromium Molybdenum-

Copper, Low-Carbon Nickel-Chromium Molybdenum-

Tantalum, and Low-Carbon Nickel-Chromium

N08031, UNS N08932, UNS NO8926, and UNS R20033

Plate, Sheet, and Strip

5

2.2 ASME Code:

Boiler and Pressure Vessel Code, Section IX, Welding

3.1 Definitions of Terms Specific to This Standard: Descrip-

in. (2.73 mm) and over in thickness, and over 10

This specification is under the jurisdiction of ASTM Committee A01 on Steel,

Stainless Steel and Related Alloys, and is the direct responsibility of Subcommittee

A01.17 on Flat-Rolled and Wrought Stainless Steel.

Current edition approved Feb. 10, 2003. Published April 2003. Originally

approved in 1943. Last previous edition approved in 1999 as A 265 – 94a (1999).

For ASME Boiler and Pressure Vessel Code applications see related Specifi-

Annual Book of ASTM Standards, Vol 02.04.