DESCRIPTION:
This example toggles one on-board LED using a 200ms Systick interrupt base and sends
UART messages to the PC.
REQUIREMENTS:
- J-Link Drivers installed on PC
- J-Link v4.59 or above
- XMC1200 Boot Kit (XMC1200 CPU Card)
SETUP:
- Connect XMC1200 CPU Card to USB
HOW TO CREATE THE PROJECT:
1) Create a new Empty Main Project
2) Initialize P0.0 connected to an on-board LED
3) Initialize P1.2 and P1.3 for UART communication
4) Initialize clock
5) Initialize USIC channel 1
6) Initialize Systick
7) Create SysTick interrupt handler to toggle LED and send UART messages
OBSERVATIONS:
1. The top on-board LED toggles
2. The following two alternating messages are sent to the PC @ 57.6 kbaud over VCOM:
"Visit www.infineon.com/XMC"
"Visit www.infineonforums.com"
SW_XMC1200_UART_1302.zip_XMC1200 UART
版权申诉
69 浏览量
2022-07-14
16:02:06
上传
评论
收藏 335KB ZIP 举报
SW_XMC1200_UART_1302.zip （34个子文件） 
XMC1200_UART Startup 
startup_XMC1200.s 24KB system_XMC1200.c 4KB Main.c 9KB .settings com.dave.mbs.xc800.prefs 117B .project 3KB ARM_toolset_settings_Debug.jlink 578B .cproject 19KB gpio_xmc1200_tssop38.h 32KB XMC1200_UART.ld 4KB XMC1200_UART.launch 4KB Debug XMC1200_UART.lst 70KB sources.mk 499B Startup subdir.mk 2KB system_XMC1200.o.lst 15KB system_XMC1200.o 199KB startup_XMC1200.o 7KB startup_XMC1200.d 87B startup_XMC1200.o.lst 39KB system_XMC1200.d 900B Main.d 736B subdir.mk 1017B XMC1200_UART.map 16KB Main.o.lst 162KB objects.mk 239B XMC1200_Blinky.map 16KB XMC1200_UART.elf 436KB makefile.rsp 58B Main.o 209KB makefile 2KB XMC1200_Blinky.elf 440KB XMC1200_UART.hex 6KB XMC1200_Blinky.hex 7KB XMC1200_Blinky.lst 80KB
ReadMe.txt 801B
评论0