DESCRIPTION:
This example toggles one on-board LED using a 200ms Systick interrupt base and sends
UART messages to the PC.
REQUIREMENTS:
- J-Link Drivers installed on PC
- J-Link v4.59 or above
- XMC1300 Boot Kit (XMC1300 CPU Card)
SETUP:
- Connect XMC1300 CPU Card to USB
HOW TO CREATE THE PROJECT:
1) Create a new Empty Main Project
2) Initialize P0.0 connected to an on-board LED
3) Initialize P1.2 and P1.3 for UART communication
4) Initialize clock
5) Initialize USIC channel 1
6) Initialize Systick
7) Create SysTick interrupt handler to toggle LED and send UART messages
OBSERVATIONS:
1. The top on-board LED toggles
2. The following two alternating messages are sent to the PC @ 57.6 kbaud over VCOM:
"Visit www.infineon.com/XMC"
"Visit www.infineonforums.com"
Keil_XMC1300_UART_1302.zip_xmc1300_xmc1300 uart_xmc1300串口
版权申诉
193 浏览量
2022-07-13
21:11:13
上传
评论 2
收藏 463KB ZIP 举报
Keil_XMC1300_UART_1302.zip （32个子文件） 
Keil_XMC1300_UART_1302 Startup 
system_XMC1300.c 4KB XMC1000_RomFunctionTable.h 7KB XMC1300.h 815KB system_XMC1300.h 2KB startup_XMC1300.s 15KB Keil_XMC1300_UART_1302.plg 2KB Keil_XMC1300_UART_1302.uvproj 15KB JLinkSettings.ini 650B Keil_XMC1300_UART_1302.uvgui.shangaus 137KB Keil_XMC1300_UART_1302_Target 1.dep 89B Keil_XMC1300_UART_1302_Keil_XMC1300_UART_1302.dep 858B
JLinkLog.txt 518KB Source Main.c 9KB gpio_xmc1300_tssop38.h 32KB Keil_XMC1300_UART_1302.uvopt 8KB startup_xmc1300.lst 51KB Debug Keil_XMC1300_UART_1302.axf 257KB Keil_XMC1300_UART_1302.sct 479B Keil_XMC1300_UART_1302.htm 29KB main.crf 270KB system_xmc1300.d 483B startup_xmc1300.d 54B Keil_XMC1300_UART_1302.lnp 354B system_xmc1300.o 244KB ExtDll.iex 19B system_xmc1300.crf 241KB main.d 441B Keil_XMC1300_UART_1302.hex 6KB main.o 259KB startup_xmc1300.o 6KB Keil_XMC1300_UART_1302.map 53KB ReadMe.txt 801B
评论0