STM32F0.hlb.l01.rar_STM32F0 多路ADC_stm32f0 定时_stm32f0 定时器_stm3

/** @page Template Template example @verbatim ******************** (C) COPYRIGHT 2014 STMicroelectronics ******************* * @file Template/readme.txt * @author MCD Application Team * @version V1.2.0 * @date 11-April-2014 * @brief Description of the Template example ****************************************************************************** * @attention * * <h2><center>&copy; COPYRIGHT 2014 STMicroelectronics</center></h2> * * * Licensed under MCD-ST Liberty SW License Agreement V2, (the "License"); * You may not use this file except in compliance with the License. * You may obtain a copy of the License at: * * http://www.st.com/software_license_agreement_liberty_v2 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. * ****************************************************************************** @endverbatim @par Example Description This example is used as a template project that can be used as reference to build any new firmware application for STM32 Cortex-M devices using the related Standard Peripherals Library. @par Directory contents - Template/stm32xxxx_conf.h Library Configuration file - Template/stm32xxxx_it.c Interrupt handlers - Template/stm32xxxx_it.h Interrupt handlers header file - Template/main.c Main program - Template/system_stm32xxxx.c STM32xxxx system source file @par Hardware and Software environment - This example runs on STM32F030xx Devices. - This example has been tested with STMicroelectronics STM32NUCLEO kit (MB1136) Rev C and can be easily tailored to any other supported device and development board. @par How to use it? In order to make the program work, you must do the following : + EWARM - Open the Template.eww workspace - Rebuild all files: Project->Rebuild all - Load project image: Project->Debug - Run program: Debug->Go(F5) + MDK-ARM - Open the Template.uvproj project - Rebuild all files: Project->Rebuild all target files - Load project image: Debug->Start/Stop Debug Session - Run program: Debug->Run (F5) + TrueSTUDIO: - Open the TrueSTUDIO toolchain. - Click on File->Switch Workspace->Other and browse to TrueSTUDIO workspace directory. - Click on File->Import, select General->'Existing Projects into Workspace' and then click "Next". - Browse to the TrueSTUDIO workspace directory, select the project Template. - Rebuild all project files: Select the project in the "Project explorer" window then click on Project->build project menu. - Run program: Run->Debug (F11) * <h3><center>&copy; COPYRIGHT STMicroelectronics</center></h3> */