Note: The following show ccm-manager command output was captured in a separated environment.
Router# show ccm-manager
MGCP Domain Name: Router
Total number of host: 2
Priority Status Host
============================================================
Primary Registered 10.89.129.210
First backup Backup ready 10.89.129.211
Second backup Undefined
Current active Call Manager: 10.89.129.210
Current backup Call Manager: 10.89.129.211
Redundant link port: 2428
Failover Interval: 30 seconds
Keepalive Interval: 15 seconds
Last keepalive sent: 1d00h (elapsed time: 00:00:03)
Last MGCP traffic time: 1d00h (elapsed time: 00:00:03)
Last switchover time: 04:49:39 from (10.89.129.211)
Switchback mode: Graceful
show mgcp
Use this command to verify the status of the router's MGCP parameters. You should see the IP address of the
server that you are using (172.16.1.252 in this case.) All of the other parameters were left at their default
behavior in this configuration.
VG200A# show mgcp
MGCP Admin State ACTIVE, Oper State ACTIVE - Cause Code NONE
MGCP call-agent: 172.16.1.252 Initial protocol service is MGCP
MGCP block-newcalls DISABLED
MGCP dtmf-relay codec all mode out-of-band
MGCP modem passthrough: CA
MGCP request timeout 500, MGCP request retries 3
MGCP gateway port: 2427, MGCP maximum waiting delay 3000
MGCP restart delay 0, MGCP vad DISABLED
MGCP simple-sdp ENABLED
MGCP codec type g711ulaw, MGCP packetization period 20
MGCP JB threshold lwm 30, MGCP JB threshold hwm 150
MGCP LAT threshold lmw 150, MGCP LAT threshold hwm 300
MGCP PL threshold lwm 1000, MGCP PL threshold hwm 10000
MGCP playout mode is adaptive 60, 4, 200 in msec
MGCP IP ToS low delay disabled, MGCP IP ToS high throughput disabled
MGCP IP ToS high reliability disabled, MGCP IP ToS low cost disabled
MGCP IP precedence 5, MGCP default package: line-package
MGCP supported packages: gm-package dtmf-package trunk-package line-package
hs-package
VG200A#
Table: Explanation of Fields in the show mgcp Command
Field Output Description
MGCP Admin State
...
The administrative and operational state of the MGCP daemon. The administrative
state controls starting and stopping the application using the mgcp and mgcp
block-newcalls commands. The operational state controls normal MGCP operations.
MGCP call-agent The address of the call agent specified in the mgcp command.
MGCP
block-newcalls
enabled
The state of the mgcp block-newcalls command.
The setting for the mgcp request timeout command.
Cisco_IOS_Voice_Troubleshooting_and_Monitoring_--_MGCP_Testing_Commands
show ccm-manager 2