Structure and function of the MCS-51 series
Structure and function of the MCS-51 series one-chip computer is a
name of a piece of one-chip computer series which Intel Company
produces. This company introduced 8 top-grade one-chip computers of
MCS-51 series in 1980 after introducing 8 one-chip computers of
MCS-48 series in 1976. It belong to a lot of kinds this line of one-chip
computer the chips have,such as 8051, 8031, 8751, 80C51BH,
80C31BH,etc., their basic composition, basic performance and
instruction system are all the same. 8051 daily representatives- 51 serial
one-chip computers .
An one-chip computer system is made up of several following parts:
( 1) One microprocessor of 8 (CPU). ( 2) At slice data memory RAM
(128B/256B),it use not depositting not can reading /data that write,
such as result not middle of operation, final result and data wanted to
show, etc. ( 3) Procedure memory ROM/EPROM (4KB/8KB ), is used to
preserve the procedure , some initial data and form in slice. But does
not take ROM/EPROM within some one-chip computers, such as 8031 ,
8032, 80C ,etc.. ( 4) Four 8 run side by side I/O interface P0 four P3, each
mouth can use as introduction , may use as exporting too. ( 5) Two
timer / counter, each timer / counter may set up and count in the way,
used to count to the external incident, can set up into a timing way too,
and can according to count or result of timing realize the control of the
computer. ( 6) Five cut off cutting off the control system of the source .
( 7) One all duplexing serial I/O mouth of UART (universal asynchronous
receiver/transmitter (UART) ), is it realize one-chip computer or
one-chip computer and serial communication of computer to use for.
( 8) Stretch oscillator and clock produce circuit, quartz crystal finely tune
electric capacity need outer. Allow oscillation frequency as 12
megahertas now at most. Every the above-mentioned part was joined
through the inside data bus .Among them, CPU is a core of the
one-chip computer, it is the control of the computer and command
centre, made up of such parts as arithmetic unit and controller , etc..
The arithmetic unit can carry on 8 persons of arithmetic operation and
unit ALU of logic operation while including one, the 1 storing device