万能 网卡驱动2009.7版For Win98se_ME_2000_XP_2003_Vista_Win7

IC Plus IP1000 Family Gigabit Ethernet Adapter Windows NDIS driver Contents: --------- 1. File Description 2. Driver Installation for Windows XP 3. Parameters Description 1. File Description ------------------- Filename Description ================= ===================================================== README.TXT Presents a summary of the contents for Windows NDIS driver installation. NETIPGD.INF Windows installation INFormation file for install IPGDND51.SYS Windows XP NDIS 5.1 driver 2. Driver Installation for Windows XP ------------------------------------------------ The Windows installation floppy or CD is needed to complete this installation. Adapter Installation Procedure -------------------------------------------- a. Make sure your computer is power-off. b. Plug the adapter into one PCI 33MHz slot of your computer. c. Turn on the power. Install and/or Update driver from diskette ------------------------------------------ The following steps can help you install or update the driver to the one in the Adapter Drivers Diskette/CD-ROM. a. Open Control Panel, double click "System" icon to open System Properties. b. In the "Hardware" sheet, you can see the "Device Manager" button. Click to open Device Manager. c. Use the tool bar to make sure you "View" "Devices by type". Then you will able to find Ethernet Controller in "Network Adapters" group. Double click it to open its property. d. In the "Driver" sheet of the adapter's properties, there is a button named "Update Driver". Click it, the Upgrade Device Driver Wizard will show up to help updating the driver. The following steps will lead you through the wizard ... a. The first page is the welcome messages, click "Next" to continue. b. Select "Display a list of the known drivers of this device so that I can choose a specific driver.", and click "Next". c. Click "Have Disk". d. Specify the path. (A:\ , assume A: is floppy drive) (D:\ , assume D: is CD drive) e. Choose the driver. IC Plus IP1000 Family Gigabit Ethernet Adapter Click "Next" to continue. f. The wizard will be warning you as the driver without digital signatured if its cat file not present. Click "Continue" to continue. g. The wizard will copy and load the driver, then you will see "Finish" button. Click it and it's done. 3. Parameter Description ------------------------ - Open 'Device Manager' in "My Computer" -> "Control Pannel" -> "System" Select "Hardware" and click "Device Manager". Double click "IC Plus IP1000 Family Gigabit Ethernet Adapter", Select "Advanced" item. 802.1Q/1P VLAN You can enable it for VLAN group. tagging Default: Disabled VLAN ID This value will active after 802.1Q/1P VLAN tagging is enabled. Default : 2 Connection Type Specify the connection type for the adapter. Default: Auto-Sense Flow Control Enabled/Disabled for Transmit/Receive Flow Control. Default : Enabled Network Address Set the Ethernet address for your adapter. It is not recommended to use this. Default: read address from adapter ROM. Receive Buffers Set the number of Receive Buffers Descriptors Default : 128 Transmit BUffers Set the number of Transmit Buffers Descriptors Default : 128 Checksum Set enable to perform TCP/IP/UDP Checksum Offloading. Offloading Default : Enabled Jumbo Frame You can enable this for Jumbo frame support. Support Default: Disabled If enaled, jumbo frame length ranges from 1515 to 4087. (The device or link partner should also support Jumbo frame for this function to take effect.) Wake On LAN Enabled/Disabled Wake up from Lan. LinkSpeed Default : 10MBits