没有合适的资源?快使用搜索试试~ 我知道了~
ISO 7637-2 Second Edition 2004-06-15.pdf
需积分: 5 1 下载量 72 浏览量
2022-06-23
20:23:57
上传
评论
收藏 368KB PDF 举报
温馨提示
试读
42页
ISO 7637-2 Second Edition 2004-06-15.pdf
资源详情
资源评论
资源推荐
Reference numbe
r
ISO 7637-2:2004(E)
©
ISO 2004
INTERNATIONAL
STANDARD
ISO
7637-2
Second edition
2004-06-15
Road vehicles — Electrical disturbances
from conduction and coupling —
Part 2:
Electrical transient conduction along
supply lines only
Véhicules routiers — Perturbations électriques par conduction et par
couplage —
Partie 2: Transmission des perturbations électriques transitoires par
conduction uniquement le long des lignes d'alimentation
Copyright International Organization for Standardization
Reproduced by IHS under license with ISO
Sold to:INTERTEK ETL ENTELA, 01452188
Not for Resale,2004/9/1 18:22:9 GMT
No reproduction or networking permitted without license from IHS
--`,``,,,`,`,,,`,,```,,-`-`,,`,,`,`,,`---
ISO 7637-2:2004(E)
PDF disclaimer
This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but
shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In
downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat
accepts no liability in this area.
Adobe is a trademark of Adobe Systems Incorporated.
Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation
parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In
the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.
© ISO 2004
All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,
electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or
ISO's member body in the country of the requester.
ISO copyright office
Case postale 56 • CH-1211 Geneva 20
Tel. + 41 22 749 01 11
Fax + 41 22 749 09 47
E-mail copyright@iso.org
Web www.iso.org
Published in Switzerland
ii
© ISO 2004 – All rights reserved
Copyright International Organization for Standardization
Reproduced by IHS under license with ISO
Sold to:INTERTEK ETL ENTELA, 01452188
Not for Resale,2004/9/1 18:22:9 GMT
No reproduction or networking permitted without license from IHS
--`,``,,,`,`,,,`,,```,,-`-`,,`,,`,`,,`---
ISO 7637-2:2004(E)
© ISO 2004 – All rights reserved iii
Contents Page
Foreword ............................................................................................................................................................ iv
1 Scope...................................................................................................................................................... 1
2 Normative references ........................................................................................................................... 1
3 Terms and definitions........................................................................................................................... 1
4 Test procedure ...................................................................................................................................... 1
4.1 General ................................................................................................................................................... 1
4.2 Test temperature and test voltage ...................................................................................................... 2
4.3 Voltage transient emissions test......................................................................................................... 2
4.4 Transient immunity test........................................................................................................................ 4
5 Test instrument description and specifications ................................................................................ 6
5.1 Artificial network ................................................................................................................................... 6
5.2 Shunt resistor R
s
................................................................................................................................... 6
5.3 Switch S ................................................................................................................................................. 7
5.4 Power supply......................................................................................................................................... 8
5.5 Measurement instrumentation............................................................................................................. 8
5.5.1 Oscilloscope .......................................................................................................................................... 8
5.5.2 Voltage probe ........................................................................................................................................ 9
5.5.3 Waveform acquisition equipment ....................................................................................................... 9
5.6 Test pulse generator for immunity testing ......................................................................................... 9
5.6.1 Test pulse 1 ......................................................................................................................................... 10
5.6.2 Test pulses 2a and 2b......................................................................................................................... 11
5.6.3 Test pulses 3a and 3b......................................................................................................................... 13
5.6.4 Test pulse 4 ......................................................................................................................................... 15
5.6.5 Test pulses 5a and 5b......................................................................................................................... 16
Annex A (normative) Failure mode severity classification .......................................................................... 18
Annex B (informative) General technique for improving device electromagnetic compatibility ............. 22
Annex C (normative) Transient emissions evaluation — Voltage waveform............................................. 23
Annex D (normative) Test pulse generator verification procedure............................................................. 26
Annex E (informative) Determination of pulse generator’s energy capability ........................................... 29
Annex F (informative) Origin of transients in road vehicle electrical systems .......................................... 33
Copyright International Organization for Standardization
Reproduced by IHS under license with ISO
Sold to:INTERTEK ETL ENTELA, 01452188
Not for Resale,2004/9/1 18:22:9 GMT
No reproduction or networking permitted without license from IHS
--`,``,,,`,`,,,`,,```,,-`-`,,`,,`,`,,`---
ISO 7637-2:2004(E)
iv © ISO 2004 – All rights reserved
Foreword
ISO (the International Organization for Standardization) is a worldwide federation of national standards bodies
(ISO member bodies). The work of preparing International Standards is normally carried out through ISO
technical committees. Each member body interested in a subject for which a technical committee has been
established has the right to be represented on that committee. International organizations, governmental and
non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the
International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization.
International Standards are drafted in accordance with the rules given in the ISO/IEC Directives, Part 2.
The main task of technical committees is to prepare International Standards. Draft International Standards
adopted by the technical committees are circulated to the member bodies for voting. Publication as an
International Standard requires approval by at least 75 % of the member bodies casting a vote.
Attention is drawn to the possibility that some of the elements of this document may be the subject of patent
rights. ISO shall not be held responsible for identifying any or all such patent rights.
ISO 7637-2 was prepared by Technical Committee ISO/TC 22, Road vehicles, Subcommittee SC 3, Electrical
and electronic equipment.
This second edition of ISO 7637-2 cancels and replaces ISO 7637-1:1990 and ISO 7637-2:1990, of which it
constitutes a technical revision. Note that ISO 7637-1:2002 cancelled and replaced ISO 7637-0:1990.
ISO 7637 consists of the following parts, under the general title Road vehicles — Electrical disturbances from
conduction and coupling:
Part 1: Definitions and general considerations
Part 2: Electrical transient conduction along supply lines only
Part 3: Vehicles with nominal 12 V or 24 V supply voltage — Electrical transient transmission by
capacitive and inductive coupling via lines other than supply lines
Copyright International Organization for Standardization
Reproduced by IHS under license with ISO
Sold to:INTERTEK ETL ENTELA, 01452188
Not for Resale,2004/9/1 18:22:9 GMT
No reproduction or networking permitted without license from IHS
--`,``,,,`,`,,,`,,```,,-`-`,,`,,`,`,,`---
INTERNATIONAL STANDARD ISO 7637-2:2004(E)
© ISO 2004 – All rights reserved 1
Road vehicles — Electrical disturbances from conduction and
coupling —
Part 2:
Electrical transient conduction along supply lines only
1 Scope
This part of ISO 7637 specifies bench tests for testing the compatibility to conducted electrical transients of
equipment installed on passenger cars and light commercial vehicles fitted with a 12 V electrical system or
commercial vehicles fitted with a 24 V electrical system — for both injection and the measurement of
transients. Failure mode severity classification for immunity to transients is also given. It is applicable to these
types of road vehicle, independent of the propulsion system (e.g. spark ignition or diesel engine, or electric
motor).
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
ISO 7637-1:2002, Road vehicles — Electrical disturbances from conduction and coupling — Part 1:
Definitions and general considerations
ISO 8854:1988, Road vehicles — Alternators with regulators — Test methods and general requirements
3 Terms and definitions
For the purposes of this document, the terms and definitions given in ISO 7637-1 apply.
4 Test procedure
4.1 General
These tests for measuring the transient emission on supply lines and the immunity of devices against such
transients are called “bench tests”, made in the laboratory.
The methods, some of which require the use of the artificial network, will provide comparable results between
laboratories. They will also give the basis for the development of devices and systems, and may be used
during the production phase (see Annex B).
A bench test method for the evaluation of the immunity of a device against supply line transients may be
performed by means of a test pulse generator; this may not cover all types of transients which can occur in a
vehicle. Therefore, the test pulses described in 5.6 are characteristic of typical pulses.
Copyright International Organization for Standardization
Reproduced by IHS under license with ISO
Sold to:INTERTEK ETL ENTELA, 01452188
Not for Resale,2004/9/1 18:22:9 GMT
No reproduction or networking permitted without license from IHS
--`,``,,,`,`,,,`,,```,,-`-`,,`,,`,`,,`---
剩余41页未读,继续阅读
MXB1
- 粉丝: 32
- 资源: 24
上传资源 快速赚钱
- 我的内容管理 展开
- 我的资源 快来上传第一个资源
- 我的收益 登录查看自己的收益
- 我的积分 登录查看自己的积分
- 我的C币 登录后查看C币余额
- 我的收藏
- 我的下载
- 下载帮助
安全验证
文档复制为VIP权益,开通VIP直接复制
信息提交成功
评论0