LD-K21609-1
1. Application
This specification applies to the color 60.0” TFT-LCD module LK600D3LA38
* These specification are proprietary products of SHARP CORPORATION (“SHARP”) and include materials
protected under copyright of SHARP. Do not reproduce or cause any third party to reproduce them in any form or by
any means, electronic or mechanical, for any purpose, in whole or in part, without the express written permission of
SHARP.
* In case of using the device for applications such as control and safety equipment for transportation (aircraft, trains,
automobiles, etc.), rescue and security equipment and various safety related equipment which require higher
reliability and safety, take into consideration that appropriate measures such as fail-safe functions and redundant
system design should be taken.
* Do not use the device for equipment that requires an extreme level of reliability, such as aerospace applications,
telecommunication equipment (trunk lines), nuclear power control equipment and medical or other equipment for
life support.
* SHARP assumes no responsibility for any damage resulting from the use of the device that does not comply with
the instructions and the precautions specified in these technical literature.
* Contact and consult with a SHARP sales representative for any questions about this device.
2. Overview
This module is a color active matrix LCD module incorporating amorphous silicon TFT (Thin Film Transistor). It is
composed of a color TFT-LCD panel, driver ICs, control circuit, power supply circuit, inverter circuit and back light
system etc. Graphics and texts can be displayed on a 1920×RGB×1080 dots panel with one billion colors by
using 8bit+FRC LVDS (Low Voltage Differential Signaling) to interface, +12V of DC supply voltages.
This module also includes the DC/AC inverter to drive the CCFT. (+24V of DC supply voltage)
And in order to improve the response time of LCD, this module applies the Over Shoot driving (O/S driving)
technology for the control circuit .In the O/S driving technology, signals are being applied to the Liquid Crystal
according to a pre-fixed process as an image signal of the present frame when a difference is found between image
signal of the previous frame and that of the current frame after comparing them.
With this technology, image signals can be set so that liquid crystal response completes within one frame. As a
result, motion blur reduces and clearer display performance can be realized.
This LCD module also adopts Double Frame Rate driving method.
With combination of these technologies, motion blur can be reduced and clearer display performance can be
realized.
3. Mechanical Specifications
Parameter Specifications Unit
152.496 （Diagonal）
cm
Display size
60.0 （Diagonal）
inch
Active area 1329.12(H) x 747.63 (V) mm
Pixel Format
1920(H) x 1080(V)
（1pixel = R + G + B dot）
pixel
Pixel pitch 0.69225(H) x 0.69225 (V) mm
Pixel configuration R, G, B vertical stripe
Display mode Normally black
Unit Outline Dimensions (*1) 1401.1(H) x 820.4(V) x 43.0(D) mm
Mass
25±1
kg
Surface treatment
Anti glare
Hard coating: 2H and more
(*1) Outline dimensions are shown in Fig.1 (excluding protruding portion)
评论0
最新资源