基于单片机的DAC0832正弦波 发生器 源码 +仿真电路图

#include<reg52.h> #define uchar unsigned char #define uint unsigned int #define DAdata P0 sbit DA_S1= P2^0; // 控制DAC0832的8位输入寄存器，仅当都为0时，可以输出数据(处于直通状态)，否则，输出将被锁存 sbit DA_S2= P2^1; // 控制DAC0832的8位DAC寄存器，仅当都为0时，可以输出数据(处于直通状态)，否则，输出将被锁存 /*uchar code tab[128]={ 64,67,70,73,76,79,82,85,88,91,94,96,99,102,104,106,109,111,113,115,117,118,120,121,123,124,125,126,126, 127,127,127,127,127,127,127,126,126,125,124,123,121,120,118,117,115,113,111,109,106,104,102,99,96,94,91, 88,85,82,79,76,73,70,67,64,60,57,54,51,48,45,42,39,36,33,31,28,25,23,21,18,16,14,12,10,9,7,6,4,3,2,1, 1,0,0,0,0,0,0,0,1,1,2,3,4,6,7,9,10,12,14,16,18,21,23,25,28,31,33,36,39,42,45,48,51,54,57,60};*/ uchar code sine_tab[256]={ //输出电压从0到最大值（正弦波1/4部分） 0x80,0x83,0x86,0x89,0x8d,0x90,0x93,0x96,0x99,0x9c,0x9f,0xa2,0xa5,0xa8,0xab,0xae,0xb1,0xb4,0xb7,0xba,0xbc, 0xbf,0xc2,0xc5,0xc7,0xca,0xcc,0xcf,0xd1,0xd4,0xd6,0xd8,0xda,0xdd,0xdf,0xe1,0xe3,0xe5,0xe7,0xe9,0xea,0xec, 0xee,0xef,0xf1,0xf2,0xf4,0xf5,0xf6,0xf7,0xf8,0xf9,0xfa,0xfb,0xfc,0xfd,0xfd,0xfe,0xff,0xff,0xff,0xff,0xff,0xff, //输出电压从最大值到0（正弦波1/4部分） 0xff,0xff,0xff,0xff,0xff,0xff,0xfe,0xfd,0xfd,0xfc,0xfb,0xfa,0xf9,0xf8,0xf7,0xf6,0xf5,0xf4,0xf2,0xf1,0xef, 0xee,0xec,0xea,0xe9,0xe7,0xe5,0xe3,0xe1,0xde,0xdd,0xda,0xd8,0xd6,0xd4,0xd1,0xcf,0xcc,0xca,0xc7,0xc5,0xc2, 0xbf,0xbc,0xba,0xb7,0xb4,0xb1,0xae,0xab,0xa8,0xa5,0xa2,0x9f,0x9c,0x99 ,0x96,0x93,0x90,0x8d,0x89,0x86,0x83,0x80, //输出电压从0到最小值（正弦波1/4部分） 0x80,0x7c,0x79,0x76,0x72,0x6f,0x6c,0x69,0x66,0x63,0x60,0x5d,0x5a,0x57,0x55,0x51,0x4e,0x4c,0x48,0x45,0x43, 0x40,0x3d,0x3a,0x38,0x35,0x33,0x30,0x2e,0x2b,0x29,0x27,0x25,0x22,0x20,0x1e,0x1c,0x1a,0x18,0x16 ,0x15,0x13, 0x11,0x10,0x0e,0x0d,0x0b,0x0a,0x09,0x08,0x07,0x06,0x05,0x04,0x03,0x02,0x02,0x01,0x00,0x00,0x00,0x00,0x00,0x00, //输出电压从最小值到0（正弦波1/4部分） 0x00,0x00,0x00,0x00,0x00,0x00,0x01,0x02 ,0x02,0x03,0x04,0x05,0x06,0x07,0x08,0x09,0x0a,0x0b,0x0d,0x0e,0x10, 0x11,0x13,0x15 ,0x16,0x18,0x1a,0x1c,0x1e,0x20,0x22,0x25,0x27,0x29,0x2b,0x2e,0x30,0x33,0x35,0x38,0x3a,0x3d, 0x40,0x43,0x45,0x48,0x4c,0x4e,0x51,0x55,0x57,0x5a,0x5d,0x60,0x63,0x66 ,0x69,0x6c,0x6f,0x72,0x76,0x79,0x7c,0x80 }; void DAout(uchar temp) { DAdata=temp; DA_S1=0; //打开8位输入寄存器 DA_S1=1; //关闭8位输入寄存器 } void main() { uchar i,k; i=0; DAdata=0; DA_S1=0; //打开8位输入寄存器 DA_S2=0; //使DAC寄存器处于直通状态 while(1) { /*for(i=0;i<255;i++) //产生三角波的上升斜边 { DAout(i); } for(i=255;i>0;i--) //产生三角波的下降斜边 { DAout(i); }*/ //DAout(0xff); //可输出TTL波形 //DAout(0x80); for(i=0;i<256;i++) //下面四个for循环，可输出正弦波 { k=sine_tab[i]; P0=k; } /*for(i=18;i>0;i--) { k=tab[i]; P0=k; } for(i=0;i<18;i++) { k=~tab[i]; P0=k; } for(i=18;i>0;i--) { k=~tab[i]; P0=k; } */ } }