KSP.zip_KSP_lpc2148_lpc2148 projects

Note: ----------------------------------------------------------------------------------------------------- 1) Go through the BlueBoard-lpc214x_UserManual. 2) The Blueboard LPC214x comes with the pre-loaded Firmware, which tests all the peripherals.You can also test peripherals individually by the hex files given and observe the output as given below. HEX files--------------------------------Output to be observed i) Adc_Led.hex Adjust POT(R8) and LED's(D1 to D8) will glow accordingly. ii) ExtInt.hex Press SW1 and you will hear beep as a interrupt. iii) Lcd.hex LCD displays "NGX TECHNOLOGIES". iv) SDCARD.hex If SD card is loaded in J24, LCD displays "SDCARD - PASS". v) USB.hex When USB connected, it displays message through hyperterminal at 9600 baudrate when any key is pressed.COM port should be the same which gets enumerated after USB is plugged. vi)BlueBoard.hex Tests all Peripherals except VGA.Observation same as all above mentioned example outputs. vi)I2C_Serial_EEPROM.hex LCD displays "I2C FLASH PASS". vii)PS2KBD_LCD.hex When connected keyboard, after pressing key the particular character,number,etc is displayed on LCD. viii)Serial.hex When half Serial Cable connected, it displays message through hyperterminal at 34800 baudrate when any key is pressed. COM port should be the same which gets enumerated after serial cable is plugged. ix) Adc_Lcd.hex Adjust POT(R8) and ADC valve will change accordingly on LCD.