XDS560
Troubleshooting Guide
Problem
Error Condition:
ISA Peripherals stop working
Possible Solution
• If the operating system of the PC is Windows NT 4, turn off the
PnP (plug-n-play) option in your BIOS.
• If the PnP option is on, then you may have to manually reserve the
IRQ (interrupt address). IRQ 10 usually is a good choice. In order to
reserve an Interrupt for a Legacy ISA device, you will need to enter
the system’s BIOS menu during boot-up. Follow your BIOS menu to
IRQ interrupts and manually reserve the interrupt address (again,
IRQ 10 is usually a good choice).
• The error incorrectly identifies the source of the error as the XDS510
port address. This error message should be ignored.
• The cable pod is not connected or is improperly connected at the
back of the PC. Verify that cable is connected and that the pod
connector's screws are tightened into the XDS560 PCI bracket.
• The target header from the XDS560 pod is not connected or is
improperly connected to a target board.
• The cable pod is not connected or is improperly connected at the
back of the PC. Verify that cable is connected and that the pod
connector's screws are tightened into the XDS560 PCI bracket.
• On some PENTEK boards, the target emulation header uses the
"Target Disconnect" pin of the XDS560. Verify that pin 4 of the
target board emulation header is grounded. If not, then add a wire-
wrap wire from pin 4 to pin 8 of the target emulation header. Refer
the XDS560 Emulator Reference Guide (SPRU589) for additional
information.
• Make sure that the target has proper voltage supplied to it.
• Check that the emulator board is securely installed.
• Check that the cabling is securely connected between the emulator
and the target.
• Make sure that the XDS560 hardware settings for the port address
correspond to those used when invoking the emulator software.
Error Message:
Can't Initialize Target CPU:
SC_ERR_CTL_CBL_BREAK_NEAR <-182>
Error Message:
Can't Initialize Target CPU:
SC_ERR_CTL_CBL_BREAK_FAR <-183>
Error Message:
I/O Port: 0x240
Error Message:
Can't Initialize Target CPU:
SC_ERR_NO_TRG_POWER <-180>
This troubleshooting guide lists errors that may be generated by your emulation tools. Use the list to find possible solutions to
your problems. For help troubleshooting XDS560 Windows driver issues, use the Driver Troubleshooting Guide, which can
be found on the start menu under the XDS560 Documentation or under /Driver/Test on the XDS560 Installation CD.
