RCC.rar_RCC_rcc cncomm_rcc saber

/******************** (C) COPYRIGHT 2008 STMicroelectronics ******************** * File Name : readme.txt * Author : MCD Application Team * Version : V2.0.3 * Date : 09/22/2008 * Description : Description of the RCC Example. ******************************************************************************** * THE PRESENT FIRMWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS * WITH CODING INFORMATION REGARDING THEIR PRODUCTS IN ORDER FOR THEM TO SAVE TIME. * AS A RESULT, STMICROELECTRONICS SHALL NOT BE HELD LIABLE FOR ANY DIRECT, * INDIRECT OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY CLAIMS ARISING FROM THE * CONTENT OF SUCH FIRMWARE AND/OR THE USE MADE BY CUSTOMERS OF THE CODING * INFORMATION CONTAINED HEREIN IN CONNECTION WITH THEIR PRODUCTS. *******************************************************************************/ Example description =================== This example shows how to configure the System clock(SYSCLK) to have different frequencies: 20MHz, 36MHz, 48MHz and 72MHz. The SYSCLK frequency is selected by user in main.h file It shows how to use, for debug purpose, the RCC_GetClocksFreq function to retrieve the current status and frequencies of different on chip clocks. You can see the RCC_ClockFreq structure content, which hold the frequencies of different on chip clocks, using your toolchain debugger. This example handles also the High Speed External clock (HSE) failure detection: when the HSE clock disappears (broken or disconnected external Quartz); HSE, PLL are disabled (but no change on PLL config), HSI selected as system clock source and an interrupt (NMI) is generated. In the NMI ISR, the HSE, HSE ready interrupt are enabled and once HSE clock recover, the HSERDY interrupt is generated and in the RCC ISR routine the system clock is reconfigured to its previous state (before HSE clock failure). You can monitor the HSE clock on the MCO pin (PA.08). Four LEDs connected to the GPIO_LED Pin 6, Pin 7, Pin 8 and Pin 9 are toggled with a timing defined by the Delay function. Note: To adjust the External High Speed oscillator (HSE) Startup Timeout value, use HSEStartUp_TimeOut variable defined in the stm32f10x_conf.h file. Directory contents ================== platform_config.h Evaluation board specific configuration file stm32f10x_conf.h Library Configuration file stm32f10x_it.c Interrupt handlers stm32f10x_it.h Header for stm32f10x_it.c main.h Main header file main.c Main program Hardware environment ==================== This example runs on STMicroelectronics STM3210B-EVAL and STM3210E-EVAL evaluation boards and can be easily tailored to any other hardware. To select the STMicroelectronics evaluation board used to run the example, uncomment the corresponding line in platform_config.h file. + STM3210B-EVAL - Use LD1, LD2, LD3 and LD4 leds connected respectively to PC.06, PC.07, PC.08 and PC.09 pins + STM3210E-EVAL - Use LD1, LD2, LD3 and LD4 leds connected respectively to PF.06, PF0.7, PF.08 and PF.09 pins How to use it ============= In order to make the program work, you must do the following : - Create a project and setup all your toolchain's start-up files - Compile the directory content files and required Library files : + stm32f10x_lib.c + stm32f10x_gpio.c + stm32f10x_rcc.c + stm32f10x_nvic.c + stm32f10x_flash.c - Link all compiled files and load your image into target memory - Run the example ******************* (C) COPYRIGHT 2008 STMicroelectronics *****END OF FILE******