基于树莓派4B的Jailhouse源码资源

# Please DO NOT modify this file; if you need to modify the boot config, the # "usercfg.txt" file is the place to include user changes. Please refer to # the README file for a description of the various configuration files on # the boot partition. # The unusual ordering below is deliberate; older firmwares (in particular the # version initially shipped with bionic) don't understand the conditional # [sections] below and simply ignore them. The Pi4 doesn't boot at all with # firmwares this old so it's safe to place at the top. Of the Pi2 and Pi3, the # Pi3 uboot happens to work happily on the Pi2, so it needs to go at the bottom # to support old firmwares. [pi4] kernel=uboot_rpi_4.bin [pi2] kernel=uboot_rpi_2.bin [pi3] kernel=uboot_rpi_3.bin [pi0] kernel=uboot_rpi_3.bin [all] device_tree_address=0x03000000 [pi4] max_framebuffers=2 arm_boost=1 [all] # Enable the audio output, I2C and SPI interfaces on the GPIO header. As these # parameters related to the base device-tree they must appear *before* any # other dtoverlay= specification dtparam=audio=on dtparam=i2c_arm=on dtparam=spi=on # Comment out the following line if the edges of the desktop appear outside # the edges of your display disable_overscan=1 # If you have issues with audio, you may try uncommenting the following line # which forces the HDMI output into HDMI mode instead of DVI (which doesn't # support audio output) #hdmi_drive=2 # Config settings specific to arm64 arm_64bit=1 dtoverlay=dwc2 [cm4] # Enable the USB2 outputs on the IO board (assuming your CM4 is plugged into # such a board) dtoverlay=dwc2,dr_mode=host [all] # The following settings are "defaults" expected to be overridden by the # included configuration. The only reason they are included is, again, to # support old firmwares which don't understand the "include" command. enable_uart=1 enable_gic=1 armstub=bl31.bin cmdline=cmdline.txt include syscfg.txt include usercfg.txt