52, 100603(2015)
激光与光电子学进展
Laser & Optoelectronics Progress
©2015《中国激光》杂志社
100603-1
双圈同轴式光纤传感器在叶尖间隙测量中的应用
贾丙辉 冯 勇 贾文华
南京工程学院机械工程学院, 江苏 南京 611167
摘要 为满足燃气轮机叶尖间隙测量需要,设计了一种双圈同轴式光纤位移传感器。根据光纤对光强耦合原理得到
了传感器探头有无准直透镜时双圈同轴光纤束的光强调制特性函数,分析了透镜对反射式光纤位移传感器测量特性
的影响,仿真评估了透镜透射效率及光的干涉对传感器测量结果的影响。进行了光纤束前端有无准直透镜情况下的
静态测量实验及模 拟烟雾干扰实验。结果表明,传感器线性测量范 围约为 2.6 mm,且具有 较 好的抗烟雾干扰能力。
为反射式光纤位移传感器在燃气轮机叶尖间隙复杂环境下的测量应用提供了参考。
关键词 传感器; 叶尖间隙; 光纤位移传感器; 烟雾干扰; 抗污染
中图分类号 TP212 文献标识码 A
doi: 10.3788/LOP52.100603
Application of Optical Sensor with Two-Circle Reflective Coaxial
Fiber in Tip Clearance Measurement
Jia Binghui Feng Yong Jia Wenhua
School of Mechanical Engineering, Nanjing Institute of Technology, Nanjing, Jiangsu 611167, China
Abstract In order to meet the measurement requirements of gas turbine tip clearance, the displacement optical
sensor with two-circle reflective coaxial fiber probe is designed. Output functions of the fiber sensor without and
with collimating lens are gained based on light intensity coupling principle analysis. The effect of lens on reflective
optical fiber displacement sensor characteristics is analyzed. Then, effect of transmission efficiency and interference
on measurement results is evaluated. The static measurement and smog interference experiment of the sensor with
and without collimating lens are completed. The results show that the linear measuring range of the sensor designed
is 2.6 mm, and the antipollution ability is proved. It provides a reference for the application of reflective optical fiber
displacement sensor in gas turbine tip clearance environment.
Key words sensors; tip clearance; optical fiber displacement sensor; smog interference; antipollution
OCIS codes 060.2300; 060.2370; 080.3630
1 引 言
发动机转子叶尖间隙的大小是影响发动机性能的重要参数之一。间隙过大会导致发动机性能降低,过
小则易发生叶尖与机匣的碰磨,甚至引发严重的事故。使发动机在工作包线内的叶尖间隙均处于最佳状态
对提 高发 动机 性能 、延 长其 工作 寿命 、降 低油 耗和 有害 气体 的排放有重要意义。叶尖间隙精密测量是实现
间隙主动控制和优化设计的重要保障。
反射式光强调制型光纤位移传感器因其结构简单、体积小、重量轻、设计灵活、带宽大、灵敏度高以及成
本低 等特 点
[1-3]
,得 到了 越来 越广 泛的应用。胡新宁等
[4]
将这 种传 感器 应用 于测量超导转子悬浮微位移;徐
晓梅
[5]
则将这种传感器与反射棱镜相结合用以孔内表面粗糙度的检测;陈启梦等
[6]
将反射式光强调制型传感
器用于液面高度的测量;韦宣等
[7]
在微动工作台的位移检测中应用了这种传感器。为提高其测量可靠性,杨
华勇等
[8-9]
分别针对传感器探头将多模光纤和单模光纤作为传光光纤条件下,研究了反射面曲率半径对光强
调制特性的影响;马惠萍等
[10- 11]
分别就平行光束、三层反射式结构的光纤束 位移传感器的特性进行了研究;
收稿日期: 2015-03-20; 收到修改稿日期: 2015-06-01; 网络出版日期: 2015-09-15
基 金项 目: 国 家自 然 科学 基 金 (51405222)、南 京 工程 学 院引 进 人 才科 研 启动 基 金 (YKJ201303)、江 苏 省自 然 科 学青 年 基
(SBK201343507)
作者简介: 贾丙辉(1983—),男,博士,讲师,主要从事光纤传感、测控技术方面的研究。E-mail: bhjia@njit.edu.cn