目录
一、 新建工程 ..........................................................................................................................3
1、点击 File 中的 New Project Wizard 选项，如下图。 .......................................................3
2、新建工程对话框 ................................................................................................................3
3、添加文件对话框 ................................................................................................................3
4、选择 FPGA 开发板型号......................................................................................................5
5、选择 EDA 工具....................................................................................................................6
6、新建工程结束 ....................................................................................................................7
二、 设计输入 ..........................................................................................................................8
A、 选择其它编辑器，如 UltraEdit ...................................................................................8
B、 直接在 Quartus 里编写代码........................................................................................8
三、 编译 ................................................................................................................................10
四、 仿真(modelsim) .............................................................................................................11
1、写测试文件 testbench.v ..................................................................................................11
2、新建一个 sim.do 文件，输入以下命令并保存..............................................................12
3、开始仿真 ..........................................................................................................................13
五、 下载到开发板上运行 ....................................................................................................15
1、 引脚分配 ....................................................................................................................15
方法一：用鼠标一个一个分配（较烦琐）.................................................................15
方法二：使用 tcl 脚本文件（更便捷）.......................................................................16
2、 编译、下载 ................................................................................................................18
六、 SignalTap 的使用 ...........................................................................................................20
1、 点击 Tools 中的 打开 SignalTap 窗口
如下图所示： ........................................................................................................................20
2、 设置参数 ....................................................................................................................21
A、 添加欲观察信号.................................................................................................21
B、 设置触发条件 ....................................................................................................21
C、 设置 Signal Configuration 面板 ..........................................................................22
3、 编译、下载 ................................................................................................................23
4、 Run analysis ................................................................................................................23
评论0
最新资源