408 4 November 2004 HCI Commands and Events
BLUETOOTH SPECIFICATION Version 2.0 + EDR [vol 3] page 408 of 814
Host Controller Interface Functional Specification
Reserved: Size: 1 Octet
Clock_Offset: Size: 2 Octets
Allow_Role_Switch: Size: 1 Octet
Return Parameters:
None.
Event(s) generated (unless masked away):
When the Controller receives the Create Connection command, the Controller
sends the Command Status event to the Host. In addition, when the LM deter-
mines the connection is established, the Controller, on both Bluetooth devices
that form the connection, will send a Connection Complete event to each Host.
The Connection Complete event contains the Connection Handle if this com-
mand is successful.
Note: no Command Complete event will be sent by the Controller to
indicate that this command has been completed. Instead, the Connection
Complete event will indicate that this command has been completed.
Value Parameter Description
0x00 Reserved, must be set to 0x00.
See “Page Scan Mode” on page 612.
Bit format Parameter Description
Bit 14-0 Bit 16-2 of CLKslave-CLKmaster.
Bit 15 Clock_Offset_Valid_Flag
Invalid Clock Offset = 0
Valid Clock Offset = 1
Value Parameter Description
0x00 The local device will be a master, and will not accept a role switch
requested by the remote device at the connection setup.
0x01 The local device may be a master, or may become a slave after
accepting a role switch requested by the remote device at the connec-
tion setup.
0x02-0xFF Reserved for future use.