没有合适的资源?快使用搜索试试~ 我知道了~
资源推荐
资源详情
资源评论
3GPP TS 34.171 V7.2.0 (2008-06)
Technical Specification
3rd Generation Partnership Project;
Technical Specification Group Radio Access Network;
Terminal conformance specification;
Assisted Global Positioning System (A-GPS);
Frequency Division Duplex (FDD)
(Release 7)
The present document has been developed within the 3
r
d
Generation Partnership Project (3GPP
TM
) and may be further elaborated for the purposes of 3GPP.
The present document has not been subject to any approval process by the 3GPP
Organizational Partners and shall not be implemented.
This Specification is provided for future development work within 3GPP
only. The Organizational Partners accept no liability for any use of this Specification.
Specifications and reports for implementation of the 3GPP
TM
system should be obtained via the 3GPP Organizational Partners' Publications Offices.
3GPP
3GPP TS 34.171 V7.2.0 (2008-06)2Release 7
Keywords
testing, UMTS
3GPP
Postal address
3GPP support office address
650 Route des Lucioles - Sophia Antipolis
Valbonne - FRANCE
Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16
Internet
http://www.3gpp.org
Copyright Notification
No part may be reproduced except as authorized by written permission.
The copyright and the foregoing restriction extend to reproduction in all media.
© 2008, 3GPP Organizational Partners (ARIB, ATIS, CCSA, ETSI, TTA, TTC).
All rights reserved.
3GPP
3GPP TS 34.171 V7.2.0 (2008-06)3Release 7
Contents
Foreword.............................................................................................................................................................6
1 Scope........................................................................................................................................................7
2 References................................................................................................................................................7
3 Definitions, symbols, abbreviations and equations..................................................................................8
3.1 Definitions ......................................................................................................................................................... 8
3.2 Symbols ............................................................................................................................................................. 8
3.3 Abbreviations..................................................................................................................................................... 8
3.4 Equations ........................................................................................................................................................... 9
4 General test conditions.............................................................................................................................9
4.1 GPS test conditions............................................................................................................................................ 9
4.1.1 GPS signals .................................................................................................................................................. 9
4.1.2 GPS frequency ............................................................................................................................................. 9
4.2 UTRA test conditions ........................................................................................................................................ 9
4.2.1 UTRA frequency band and frequency range................................................................................................ 9
4.2.2 UTRA frequency.......................................................................................................................................... 9
5 Performance requirements for A-GPS .....................................................................................................9
5.1 General............................................................................................................................................................... 9
5.1.1 Measurement parameters.............................................................................................................................. 9
5.1.1.1 UE based A-GPS measurement parameters............................................................................................ 9
5.1.1.2 UE assisted A-GPS measurement parameters ........................................................................................ 9
5.1.1.3 2D position error................................................................................................................................... 10
5.1.1.4 Response time....................................................................................................................................... 10
5.2 Sensitivity ........................................................................................................................................................ 10
5.2.1 Sensitivity Coarse Time Assistance ........................................................................................................... 10
5.2.1.1 Definition and applicability.................................................................................................................. 10
5.2.1.2 Minimum requirements ........................................................................................................................ 10
5.2.1.3 Test purpose.......................................................................................................................................... 10
5.2.1.4 Method of test....................................................................................................................................... 10
5.2.1.4.1 Initial conditions ............................................................................................................................. 10
5.2.1.4.2 Procedure ........................................................................................................................................ 11
5.2.1.5 Test Requirements ................................................................................................................................ 11
5.2.2 Sensitivity Fine Time Assistance ............................................................................................................... 12
5.2.2.1 Definition and applicability.................................................................................................................. 12
5.2.2.2 Minimum requirements ........................................................................................................................ 12
5.2.2.3 Test purpose.......................................................................................................................................... 12
5.2.2.4 Method of test....................................................................................................................................... 12
5.2.2.4.1 Initial conditions ............................................................................................................................. 12
5.2.2.4.2 Procedure ........................................................................................................................................ 13
5.2.2.5 Test Requirements ................................................................................................................................ 13
5.3 Nominal Accuracy ........................................................................................................................................... 14
5.3.1 Definition and applicability........................................................................................................................ 14
5.3.2 Minimum requirements .............................................................................................................................. 14
5.3.3 Test purpose ............................................................................................................................................... 14
5.3.4 Method of test ............................................................................................................................................ 14
5.3.4.1 Initial conditions................................................................................................................................... 14
5.3.4.2 Procedure.............................................................................................................................................. 14
5.3.5 Test Requirements...................................................................................................................................... 15
5.4 Dynamic Range ............................................................................................................................................... 16
5.4.1 Definition and applicability........................................................................................................................ 16
5.4.2 Minimum requirements .............................................................................................................................. 16
5.4.3 Test purpose ............................................................................................................................................... 16
5.4.4 Method of test ............................................................................................................................................ 16
5.4.4.1 Initial conditions................................................................................................................................... 16
5.4.4.2 Procedure.............................................................................................................................................. 16
5.4.5 Test Requirements...................................................................................................................................... 17
3GPP
3GPP TS 34.171 V7.2.0 (2008-06)4Release 7
5.5 Multi-path Performance................................................................................................................................... 18
5.5.1 Definition and applicability........................................................................................................................ 18
5.5.2 Minimum requirements .............................................................................................................................. 18
5.5.3 Test purpose ............................................................................................................................................... 18
5.5.4 Method of test ............................................................................................................................................ 18
5.5.4.1 Initial conditions................................................................................................................................... 18
5.5.4.2 Procedure.............................................................................................................................................. 18
5.5.5 Test Requirements...................................................................................................................................... 19
5.6 Moving Scenario and Periodic Update Performance ....................................................................................... 20
5.6.1 Definition and applicability........................................................................................................................ 20
5.6.2 Minimum requirements .............................................................................................................................. 20
5.6.3 Test purpose ............................................................................................................................................... 20
5.6.4 Method of test ............................................................................................................................................ 20
5.6.4.1 Initial conditions................................................................................................................................... 20
5.6.4.2 Procedure.............................................................................................................................................. 21
5.6.5 Test Requirements...................................................................................................................................... 22
Annex A (informative): Connection Diagrams ....................................................................................23
Annex B (normative): Converting UE-assisted measurement reports into position estimates....25
B.1 Introduction............................................................................................................................................25
B.2 UE measurement reports ........................................................................................................................25
B.3 WLS position solution............................................................................................................................25
Annex C (normative): Propagation Conditions................................................................................28
C.1 General ...................................................................................................................................................28
C.2 Propagation Conditions for GPS Signals ...............................................................................................28
C.2.1 Static propagation conditions........................................................................................................................... 28
C.2.2 Multi-path conditions....................................................................................................................................... 28
Annex D (normative): Generic procedures.......................................................................................29
D.1 General ...................................................................................................................................................29
D.2 UTRAN connection set up .....................................................................................................................29
D.2.1 Initial conditions .............................................................................................................................................. 29
D.2.2 Procedures........................................................................................................................................................ 29
D.2.3 Specific message contents ............................................................................................................................... 30
D.3 UTRAN connection release ...................................................................................................................30
D.3.1 Procedure......................................................................................................................................................... 30
D.3.2 Specific message contents ............................................................................................................................... 30
Annex E (normative): Environmental conditions ............................................................................31
E.1 General ...................................................................................................................................................31
E.2 Environmental requirements ..................................................................................................................31
E.2.1 Temperature..................................................................................................................................................... 31
E.2.2 Voltage............................................................................................................................................................. 31
Annex F (normative): General test conditions and declarations....................................................32
F.1 Acceptable uncertainty of Test System..................................................................................................32
F.1.1 Measurement of test environments .................................................................................................................. 32
F.1.2 A-GPS Performance requirements................................................................................................................... 33
F.2 Test Tolerances (This clause is informative) .........................................................................................33
F.2.1 A-GPS Performance requirements................................................................................................................... 34
3GPP
3GPP TS 34.171 V7.2.0 (2008-06)5Release 7
F.3 Interpretation of measurement results....................................................................................................34
F.4 Derivation of Test Requirements (This clause is informative) ..............................................................35
F.5 Acceptable uncertainty of Test Equipment (This clause is informative) ...............................................35
F.5.1 A-GPS Performance measurements................................................................................................................. 36
F.6 General rules for statistical testing.........................................................................................................36
F.6.1 Statistical testing of 2 D position error and TTFF ........................................................................................... 36
F.6.1.1 Test Method ............................................................................................................................................... 36
F.6.1.2 Error Ratio (ER)......................................................................................................................................... 36
F.6.1.3 Test Design................................................................................................................................................. 36
F.6.1.3.1 Confidence level................................................................................................................................... 36
F.6.1.3.2 Introduction: Supplier Risk versus Customer Risk............................................................................... 36
F.6.1.3.3 Supplier Risk versus Customer Risk .................................................................................................... 37
F.6.1.3.4 Introduction: Standard test versus early decision concept.................................................................... 37
F.6.1.3.5 Standard test versus early decision concept.......................................................................................... 38
F.6.1.3.6 Selectivity............................................................................................................................................. 38
F.6.1.3.7 Design of the test .................................................................................................................................. 39
F.6.1.4 Pass fail decision ........................................................................................................................................ 40
F.6.1.4.1 Numerical definition of the pass fail limits .......................................................................................... 40
F.6.1.4.2 Pass fail decision rules.......................................................................................................................... 41
F.6.1.4.3 Background information to the pass fail limits..................................................................................... 41
Annex G (normative): Test case applicability and ICS proforma for 3
rd
Generation User
Equipment ......................................................................................................
43
G.1 Recommended test case applicability.....................................................................................................43
G.2 Guidance for completing the ICS proforma...........................................................................................44
G.2.1 Purposes and structure ..................................................................................................................................... 44
G.2.2 Abbreviations and conventions........................................................................................................................ 44
G.2.3 Instructions for completing the ICS proforma ................................................................................................. 45
G.3 Identification of the User Equipment.....................................................................................................45
G.3.1 Date of the statement ....................................................................................................................................... 45
G.3.2 User Equipment Under Test (UEUT) identification........................................................................................ 45
G.3.3 Product supplier............................................................................................................................................... 46
G.3.4 Client ............................................................................................................................................................... 46
G.3.5 ICS contact person........................................................................................................................................... 47
G.4 Identification of the protocol..................................................................................................................47
G.5 ICS proforma tables ...............................................................................................................................47
G.5.1 UE Implementation Types............................................................................................................................... 47
G.5.2 UE Service Capabilities................................................................................................................................... 48
G.5.3 Additional information .................................................................................................................................... 48
Annex H (informative): Change history ..............................................................................................49
剩余48页未读,继续阅读
资源评论
saivonking
- 粉丝: 1
- 资源: 2
上传资源 快速赚钱
- 我的内容管理 展开
- 我的资源 快来上传第一个资源
- 我的收益 登录查看自己的收益
- 我的积分 登录查看自己的积分
- 我的C币 登录后查看C币余额
- 我的收藏
- 我的下载
- 下载帮助
最新资源
- pta题库答案c语言之树结构2ListLeaves.zip
- pta题库答案c语言之树结构1树的同构.zip
- 基于C++实现民航飞行与地图简易管理系统可执行程序+说明+详细注释.zip
- pta题库答案c语言之复杂度1最大子列和问题.zip
- 三维装箱问题(Three-Dimensional Bin Packing Problem,3D-BPP)是一个经典的组合优化问题
- 以下是一些关于Linux线程同步的基本概念和方法.txt
- 以下是一个简化的示例,它使用pygame库来模拟烟花动画的框架.txt
- Linux线程同步机制深度解析与实用指南.zip
- PTA题库C语言解题策略与实战.rar
- SVPWM控制技术的simulink建模与仿真【包括simulink模型,参考文献,操作步骤】
资源上传下载、课程学习等过程中有任何疑问或建议,欢迎提出宝贵意见哦~我们会及时处理!
点击此处反馈
安全验证
文档复制为VIP权益,开通VIP直接复制
信息提交成功