NodeMCU固件(LUA)上带有ESP01(ESP8266)和RCWL-0516微波运.zip

# WiFi motion sensor with ESP01 (ESP8266) and RCWL-0516 microwave motion sensor module on NodeMCU firmware (LUA)    Function | GPIO | NodeMCU --- | --- | --- RCWL-0516 out to ESP01 through 1K ohm resistor | 2 | 4 Led through 100 ohm resistor | 0 | 3 ## Hardware - Controller ESP01S (on ESP8266 chip) - RCWL-0516 microwave motion sensor - Resistors: 100 ohm and 1K ohm - Led - AMS1117 3.3v voltage regulator - Hi-Link HLK-PM01 5v power supply ## MQTT Outgoing messages - /home/iot/{Device-IP}/out/online *- ON - connectted to MQTT, OFF - disconnected (LWT)* - /home/iot/{Device-IP}/out/motion *- ON or OFF* - /home/iot/{Device-IP}/out/state/uptime *- Up time in seconds* - /home/iot/{Device-IP}/out/state/memory *- Free memory in bytes* - /home/iot/{Device-IP}/out/state/relay *- Relay status ON or OFF* Input messages - /home/iot/{Device-IP}/in/state/uptime *No message* - /home/iot/{Device-IP}/in/state/memory *No message* - /home/iot/{Device-IP}/in/state/relay *No message* ## Installation 1. Install integer NodeMCU formware with modules: *file, gpio, mqtt, net, node, tmr, uart, wifi* (http://nodemcu-build.com/) 2. Install nodemcu-tool: *npm install nodemcu-tool -g* 3. Run *./upload.sh* to upload code