LCD DISPLAY ON THE EXPERIMENTER’S BOARD
This document has the required information necessary to run the example code that
interfaces the MSP430FG4618 to the LCD.
Note: Read the Experimenter's User's Guide and the FET User's Guide documents for
more information.
Requirements
Figure 1 shows the board with the associated jumpers and their configuration for proper
functionality of the demonstration.
Place to power
FG4618. Use also
to measure current.
Place to locally power
board from 2xAAA
batteries. In this case,
use also to measure
the total board
current consumption.
Lower 3 pins. Used for FG4618 / JTAG1.
Upper 3 pins. Used for F2013 / JTAG2.
Jumper to “LCL” to provide local VCC to FET interface.
(shown).
Jumper to “FET” to power board from the FET interface.
(In this case, the
jumper must not be set.)
Place to allow
LED4 operation
(FG4618 – P5.1)
FET tool connector to
program / debug the
MSP430FG4618.
