8169千兆网卡驱动程序

+====================================================================+ | REALTEK RTL Gigabit and Fast Ethernet NIC Driver Setup Utility | | for Windows ME/2000/XP NDIS Driver | | Release Note | +====================================================================+ How to use this RTLSetup Utility --------------------------------- For Windows ME: 1. If the Operating System's New Hardware Wizard prompts you that "New Hardware Found" for the "PCI Ethernet Controller", you should click "Next" until "Finish" is clicked and without specifying location of the driver. You will see the "PCI Ethernet Controller" in the Device Manager. 2. Then you can install or update the NDIS driver with "setup" or "setup -s" command: a) setup: The InstallShield will prompt you the steps to install or upgrade the driver. b) setup -s: The InstallShield will complete the installation or upgrade without prompting you any instruction. You need to reboot the system immediately after the Install shield completes the installation/upgrade. 3. Do not click "Cancel" during New Hardware Wizard searches for the driver. 4. You can remove RTLSetup utility from Add/Remove Program Palette in Control Panel, the InstallShield will prompt you the steps to remove the driver. After remove the driver, please restart the system immediately. For Windows 2000/XP: 1. If the Operating System's Found New Hardware Wizard prompts you that "New Hardware Found" for the "Ethernet Controller", you should click "Next" until "Finish" is clicked and without specifying location of the driver. You will see the "Ethernet Controller" in the Device Manager. 2. Then you can install or upgrade the NDIS driver with "setup" or "setup -s" command: a) setup: The InstallShield will prompt you the steps to install or upgrade the driver. b) setup -s: The InstallShield will complete the installation or upgrade without prompting you any instruction. 3. You can remove RTLSetup utility from Add/Remove Program Palette in Control Panel, the InstallShield will prompt you the steps to remove the driver. After remove the driver, please restart the system immediately if you want your networking to be re-installed.