单片机GD32E23x的工程模板

/*! \file readme.txt \brief description of using the I2C bus to write and read EEPROM \version 2019-02-19, V1.0.0, firmware for GD32E23x */ /* Copyright (c) 2019, GigaDevice Semiconductor Inc. All rights reserved. Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met: 1. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer. 2. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution. 3. Neither the name of the copyright holder nor the names of its contributors may be used to endorse or promote products derived from this software without specific prior written permission. THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. */ This demo is based on the GD32E230C-EVAL-V1.1 board, it provides a description of how to use the I2C bus to write and read EEPROM. The access result will be printed by COM. Procedures sequentially writes 256 bytes of data to the EEPROM from the 0x00 address, and then the program sequentially reads 256 bytes of data from the EEPROM from the 0x00 address. Compare the written data and read data, if the same,"I2C-AT24C02 test passed!" will be printed, while the board of the four LED lights start flashing, otherwise "Err:data read and write aren't matching." will be printed, while the four LEDs light will on.