基于F407ZGT6核心板实现远程的传感网雏形及K210的人脸识别与口罩识别C源码.zip

/** ****************************************************************************** * @file stm32f479xx.h * @author MCD Application Team * @brief CMSIS STM32F479xx Device Peripheral Access Layer Header File. * * This file contains: * - Data structures and the address mapping for all peripherals * - peripherals registers declarations and bits definition * - Macros to access peripheral’s registers hardware * ****************************************************************************** * @attention * * <h2><center>&copy; Copyright (c) 2017 STMicroelectronics. * All rights reserved.</center></h2> * * This software component is licensed by ST under BSD 3-Clause license, * the "License"; You may not use this file except in compliance with the * License. You may obtain a copy of the License at: * opensource.org/licenses/BSD-3-Clause * ****************************************************************************** */ /** @addtogroup CMSIS_Device * @{ */ /** @addtogroup stm32f479xx * @{ */ #ifndef __STM32F479xx_H #define __STM32F479xx_H #ifdef __cplusplus extern "C" { #endif /* __cplusplus */ /** @addtogroup Configuration_section_for_CMSIS * @{ */ /** * @brief Configuration of the Cortex-M4 Processor and Core Peripherals */ #define __CM4_REV 0x0001U /*!< Core revision r0p1 */ #define __MPU_PRESENT 1U /*!< STM32F4XX provides an MPU */ #define __NVIC_PRIO_BITS 4U /*!< STM32F4XX uses 4 Bits for the Priority Levels */ #define __Vendor_SysTickConfig 0U /*!< Set to 1 if different SysTick Config is used */ #define __FPU_PRESENT 1U /*!< FPU present */ /** * @} */ /** @addtogroup Peripheral_interrupt_number_definition * @{ */ /** * @brief STM32F4XX Interrupt Number Definition, according to the selected device * in @ref Library_configuration_section */ typedef enum { /****** Cortex-M4 Processor Exceptions Numbers ****************************************************************/ NonMaskableInt_IRQn = -14, /*!< 2 Non Maskable Interrupt */ MemoryManagement_IRQn = -12, /*!< 4 Cortex-M4 Memory Management Interrupt */ BusFault_IRQn = -11, /*!< 5 Cortex-M4 Bus Fault Interrupt */ UsageFault_IRQn = -10, /*!< 6 Cortex-M4 Usage Fault Interrupt */ SVCall_IRQn = -5, /*!< 11 Cortex-M4 SV Call Interrupt */ DebugMonitor_IRQn = -4, /*!< 12 Cortex-M4 Debug Monitor Interrupt */ PendSV_IRQn = -2, /*!< 14 Cortex-M4 Pend SV Interrupt */ SysTick_IRQn = -1, /*!< 15 Cortex-M4 System Tick Interrupt */ /****** STM32 specific Interrupt Numbers **********************************************************************/ WWDG_IRQn = 0, /*!< Window WatchDog Interrupt */ PVD_IRQn = 1, /*!< PVD through EXTI Line detection Interrupt */ TAMP_STAMP_IRQn = 2, /*!< Tamper and TimeStamp interrupts through the EXTI line */ RTC_WKUP_IRQn = 3, /*!< RTC Wakeup interrupt through the EXTI line */ FLASH_IRQn = 4, /*!< FLASH global Interrupt */ RCC_IRQn = 5, /*!< RCC global Interrupt */ EXTI0_IRQn = 6, /*!< EXTI Line0 Interrupt */ EXTI1_IRQn = 7, /*!< EXTI Line1 Interrupt */ EXTI2_IRQn = 8, /*!< EXTI Line2 Interrupt */ EXTI3_IRQn = 9, /*!< EXTI Line3 Interrupt */ EXTI4_IRQn = 10, /*!< EXTI Line4 Interrupt */ DMA1_Stream0_IRQn = 11, /*!< DMA1 Stream 0 global Interrupt */ DMA1_Stream1_IRQn = 12, /*!< DMA1 Stream 1 global Interrupt */ DMA1_Stream2_IRQn = 13, /*!< DMA1 Stream 2 global Interrupt */ DMA1_Stream3_IRQn = 14, /*!< DMA1 Stream 3 global Interrupt */ DMA1_Stream4_IRQn = 15, /*!< DMA1 Stream 4 global Interrupt */ DMA1_Stream5_IRQn = 16, /*!< DMA1 Stream 5 global Interrupt */ DMA1_Stream6_IRQn = 17, /*!< DMA1 Stream 6 global Interrupt */ ADC_IRQn = 18, /*!< ADC1, ADC2 and ADC3 global Interrupts */ CAN1_TX_IRQn = 19, /*!< CAN1 TX Interrupt */ CAN1_RX0_IRQn = 20, /*!< CAN1 RX0 Interrupt */ CAN1_RX1_IRQn = 21, /*!< CAN1 RX1 Interrupt */ CAN1_SCE_IRQn = 22, /*!< CAN1 SCE Interrupt */ EXTI9_5_IRQn = 23, /*!< External Line[9:5] Interrupts */ TIM1_BRK_TIM9_IRQn = 24, /*!< TIM1 Break interrupt and TIM9 global interrupt */ TIM1_UP_TIM10_IRQn = 25, /*!< TIM1 Update Interrupt and TIM10 global interrupt */ TIM1_TRG_COM_TIM11_IRQn = 26, /*!< TIM1 Trigger and Commutation Interrupt and TIM11 global interrupt */ TIM1_CC_IRQn = 27, /*!< TIM1 Capture Compare Interrupt */ TIM2_IRQn = 28, /*!< TIM2 global Interrupt */ TIM3_IRQn = 29, /*!< TIM3 global Interrupt */ TIM4_IRQn = 30, /*!< TIM4 global Interrupt */ I2C1_EV_IRQn = 31, /*!< I2C1 Event Interrupt */ I2C1_ER_IRQn = 32, /*!< I2C1 Error Interrupt */ I2C2_EV_IRQn = 33, /*!< I2C2 Event Interrupt */ I2C2_ER_IRQn = 34, /*!< I2C2 Error Interrupt */ SPI1_IRQn = 35, /*!< SPI1 global Interrupt */ SPI2_IRQn = 36, /*!< SPI2 global Interrupt */ USART1_IRQn = 37, /*!< USART1 global Interrupt */ USART2_IRQn = 38, /*!< USART2 global Interrupt */ USART3_IRQn = 39, /*!< USART3 global Interrupt */ EXTI15_10_IRQn = 40, /*!< External Line[15:10] Interrupts */ RTC_Alarm_IRQn = 41, /*!< RTC Alarm (A and B) through EXTI Lin