没有合适的资源?快使用搜索试试~ 我知道了~
SMT标准smema接口线路
4星 · 超过85%的资源 需积分: 47 105 下载量 190 浏览量
2013-05-23
22:52:31
上传
评论 2
收藏 74KB PDF 举报
温馨提示
试读
5页
SMT标准smema接口线路图,希望帮助到你地
资源推荐
资源详情
资源评论
Interface Standard 1.2
1
SMEMA
Surface Mount Equtpment Manufacturers Association
SMEMA Mechanical Equipment Interface Standard
Introduction
The SMEMA machine interface standards were developed to facilitate the interface of equipment used in the
manufacture of surface-mounted printed circuit boards. This standard is for Mechanical interfaces.
Purpose
The purpose of this standard is to provide an equipment interface specification for single board transfer
manufacturing systems of surface-mounted printed circuit boards. This specification provides the minimum
requirement that conveyor-to-conveyor equipment must meet, and does not represent a complete specification for
the equipment's interface. Conformance to the standard may be achieved by the appropriate design of the
equipment or by providing special adaptors which enable the equipment to meet the standard.
Specifications
The mechanical specifications that follow are for single board transfer systems with conveyor transports. These
systems can be assembled next to each other without any interface hardware. The printed circuit board is assumed
to move from left to right in the diaVr2n, E that follow; however, the same standard applies for systems when the
board moves from right to left. An equipment manufacturer must clearly state the direction of board movement.
1.) Conveyor height Each machine must have the transport conveyor height adjustable from 37" to
38" from the floor to the bottom of the PC board.
2.) Conveyor width For equipment with an adjustable conveyor width, the front rail is fixed and the
rear rail is adjustable. The range of adjustment will vary with the equipment
manufacturer.
3.) Edge clearance The conveyor should require no more than 0. 187" of clear board space at the
side edges.
4.) Tooling pins Tooling pins should be on the front edge of the board (next to the fixed transport
rail). A recommended hole diameter is 0.156"
(+.003, -.000). Distance from the edge is 0.300" + .010".
5.) Maximum gap The maximum gap between the in-line machine track ends is .375".
6.) Lead-in The minimum lead-in on the track ends of the conveyor is .1 25".
资源评论
- qq1232228662013-08-21感觉还不错,蛮实用用的 谢谢了,
- oQiDianTianXia2014-09-25有用,只是写得不够详细,如果每一条 线的含义都注明了就更好了
- feiyang1292013-08-26有用的,就是不清楚
zhozhong
- 粉丝: 1
- 资源: 4
上传资源 快速赚钱
- 我的内容管理 展开
- 我的资源 快来上传第一个资源
- 我的收益 登录查看自己的收益
- 我的积分 登录查看自己的积分
- 我的C币 登录后查看C币余额
- 我的收藏
- 我的下载
- 下载帮助
安全验证
文档复制为VIP权益,开通VIP直接复制
信息提交成功