Modbus Slave v6.0.2.826

------------------------------------------------------------------------------------ Modbus Slave Copyright (c) Witte Software. 2002-2014. ------------------------------------------------------------------------------------ Getting started: ----------------------------- 1. Press F3 to setup a connection. 2. Press F8 to setup protocol definition. Example: You want to simulate 20 holding registers from address 40011 (10). - Slave ID = The ID of your device - Function = 03 Read Holding Registers - Address = 10 (Protocol address) - Quantity = 20 3. To change a value just start typing. Note: you can always press F1 for help. Modbus Slave overview: ----------------------------- Modbus Slave is a powerful, easy to use, slave simulating tool. Modbus Slave will run on all 32-bit Windows versions in use today - Windows 2000, XP and Vista. You can open up to 32 windows each containing a slave/data area. A window can simmulate up to 4096 coils or 2048 registers. OLE Automation for interfacing with Visual Basic Excel etc. See included example how to edit data with Excel. Note: In Windows it is not possible to measure the 3.5 character idle time between two Modbus frames. That means that it may not be possible to use Modbus Slave in parallel with another slave device unless you are sure that the delay in the slave is > 20ms. Order information: -------------------------- Visit http://www.modbustools.com If not registered you are allowed to use the software in a 30 days trial period. Technical Support: -------------------------- Your feedback is very important for the further development of Modbus Slave. For bug reports, comments, suggestions or complaints, please find contact information at http://www.modbustools.com