Install and Run the SDM Demo Application
1. Extract the zip file SDM_demo_tool.zip.
2. Copy the 'dataFile.zip' to C:\
3. Have latest SDM2.3.2 build installed in your PC. If you do not have the SDM2.3.2 installed, you
could get the build from the location http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm
4. Disable any active pop-up blockers in the web browser that you will use to run SDM.
5. When SDM is installed on a PC , Internet Explorer may display HTML source
code when you attempt to launch SDM. To !x this problem, go to Tools >
Internet Options > Advanced. Then scroll to the Security section, check
Allow active content to run in les on my computer, and click Apply.
Then relaunch SDM.
6. Click on the Cisco SDM icon on your desktop to launch the SDM demo version. Enter the
loopback address 127.0.0.1 and click on the launch button to start the SDM demo application.
Accept any security certificate notification messages that pop up.
7. Use the ca.cer and router.cer certificates to demonstrate importing Certificate Authority (CA) and
Router certificates. You could get these certificates from SDM_demo_tool.zip.
Caveats
Following features are currently not fully supported on the demo application8even though they show up on
the SDM user interface -
a. SDM Updates88888888
b. Reset to Factory88888
c. File Management8888
d. Management access
e. Troubleshooting8888888
f. CLI Views88
g. IPS – Edit IPS signatures, SDEE messages
h. VPN – PKI enrollment wizard
i. WebVPN – Installing svc and csd application
j. Config Editor
k. Secure Device Provisioning (SDP)
l. Router Provisioning
