查看文章
ANSYS Workbench 的一个简单的结构分析实例
2007年12月18日 星期二 上午 08:43
这个实例的主要目的是让不太熟悉ANSYS Workbench的人了解利用ANSYS Workbench分析的一个大概流程。我用的软件版本
是ANSYS Workbench11.0,如果你用的不是这个版本,其中的菜单和命令可能会有所不同
。
下面所使用的实例是Ansys 帮助文档中一个非常经典的例子。在11.0版本中在Release 11.0 Documentation for ANSYS/ANSYS
Tutorials/Structual Tutorial下面。这里我也不做翻译了直接拷贝过来。不过有一点需要注意的是,在Ansys Workbench中圆并不是用
四条圆弧来表示的,因此这个例子中的载荷难以按照要求在Ansys Workbench中施加,不过在Ansys Workbench中提供了一个轴承
载荷,与这个载荷相似,只不过这个载荷的两侧的压力均为0。因此会和Ansys所得到的结果在载荷施加处略有不同,但是对于这个
问题并不影响,原因是危险区域不在这里。经过计算垂直方向的等效载荷为134.59lbf(精确值为20+360/pi,有兴趣的可以用微积分
算一下)。
材料参数(单位均为英制)。杨氏模量:30e6 psi;泊松比:0.27;厚度:0.5 inch。
载荷:134.59lbf,方向向下。
Problem Description
This is a simple, single load step, structural static analysis of the corner angle bracket shown below. The upper left-hand pin hole
is constrained (welded) around its entire circumference, and a tapered pressure load is applied to the bottom of the lower right-
hand pin hole. The objective of the problem is to demonstrate the typical ANSYS analysis procedure. The US Customary system
of units is used.
Now let's go!
1. 启动ANSYS Workbench。开始->程序->ANSYS11.0->ANSYS Workbench。启动后,界面如下。
ANSYS Workbench 启动界面
2. 进入几何建模模块。在ANSYS Workbench 启动界面中点击Geometry,进入几何建模模块,进入时,会弹出一个要求选择单位的对话
坚
持
修身
,
齐
家
,
治
国
,
平天下
。
主页
博客
相册
|
个人档案
|
好友
Page 1 of 7ANSYS Workbench 的一个简单的结构分析实例_坚持
2008-11-1http://hi.baidu.com/baolinhu/blo
g
/item/a163dc315ca8481aeac4afc6.html