IEC62133电芯安全测试

IEC62133 中电池安全测试要求总括：

2.1 绝缘和布线 (Insulation and wiring)

具体要求：正极与电池(组)外漏金属表面，除电气接触表面间的绝缘阻值在 500V d.c 时，不可

小于 5 MΩ

The insulation resistance between the positive terminal and externally exposed metal surfaces

of the battery excluding electrical contact surfaces shall be not less than 5 MΩat 500 V d.c.

3 形式測試條件

Type test conditions

10HZ~55HZ 的条件下振动(10HZ~55HZ~10HZ 为一个循环)，在 90±5min 内恢复电池。

Fully charged cells or batteries are vibration-tested under the following test conditions and

the sequence in Table 2. A simple harmonic motion is applied to the cells or batteries with

an amplitude of0,76mm, and a total maximum excursion of 1,52 mm. The frequency is varied at the

rate of 1 Hz/min between the limits of 10 Hz and 55 Hz. The entire range of frequencies (10Hzto 55

Hz) and return (55 Hz to 10 Hz), is traversed in 90 min ±5min for each mounting position (direction of

vibration). The vibration is applied in each of three mutually perpendicular directions, in the sequence

specified below.

Step 1: Verify that the measured voltage is typical of the charged product being tested.

Steps 2-4: Apply the vibration as specified in Table 2.