Table of Content
Download Repetier-Host Firmware -------------------------------------------------------- 3
Download Arduino Software ---------------------------------------------------------------- 4
Upload Repetier-Host Firmware
Download Repetier-Host Firmware
Your Mega 2560 board was shipped without pre-installed firmware. To control
your printer, please first download the pre-configured Repetier-Host firmware
from our website: Repetier-Host for Rostock Mini Pro.
Download Arduino Software
To upload firmware to your electronics, you will need to download and install
the latest Arduino interface: http://arduino.cc/en/main/software
You might have to run the file as the administrator for proper installation. To
do this, right click the installation file and select “run as administrator”.
If you have trouble opening the Arduino Software (i.e. It’s not responding after
you double-click), than you have to open it as the administrator as well.
Upload Repetier-Host Firmware
1. Open the Arduino Software (run as administrator if it’s not responding)
2. Select “Tools” -> “Board” -> “Arduino Mega 2560 (ATmega 1280)
3. Connect RAMPS 1.4 to your computer ‘s USB port and select the right
serial port. If you have no other USB device connected than you should see
only one COM port.
- 1
- 2
- 3
- 4
前往页