Axles = "Amount of axles"（轴数）
State = State （状态）
Version = Versions （版本）
SiteSpec = "Site Specific Data"（数据配置）
Information = Information （信息）
Protocol_Fault = "Protocol Fault" （协议故障）
Address_Fault = "Address Fault" （地址故障）
Software_Information = Software-Information （软件信息）
DP_Fault = "Detection Point Fault" （计轴点故障）
DP_Information = Detection-Point-Information（计轴点信息）
DP_Transmission = Detection-Point-Transmission（计轴点传输）
RSTWA_Fault = Relay-SW-Interface-Fault （继电器接点故障）
RSTWA_Information = Relay-SW-Interface-Information（继电器接点信息）
RSTWA_Command_Refusal = "Command rejected" （无效指令）
IO_Fault = IO-Fault （输入输出故障）
IO_Command_Refusal = IO-command-refusal （输入输出无效指令）
IO_Command = Command
OCS_Information = OCS-Information
OCS_Fault = OCS-Fault
[Parameters]
// SSI and OCS
SSI = "SSI:"
ModAdr = "Module addresses:" （模块地址）
AzA = "ACE:" （计轴主机）
Abs = "Section:" （轨道区段）
Elem = "Element number:" （元件编号）
WrongElem = "Wrong Element number:" （错误的元件编号）
OCSProg = "OCS in commissioning" （OCS 在使用）
OCSClose = "OCS not in operation" （OCS 在运转）
OCS1 = "OCS with one channel in operation"（OCS 一个通道在运转）
OCS2 = "OCS with two channels in operation"（OCS 两个通道在运转）
SSIAdr = "Wrong module addresses: " （模块地址出错）
// Software
SWIO = "ok"
SWNIO = "not ok"
MsgLost = " Diagnostic message(s) thrown away" （诊断信息遗失）
// Section
Occupied = "Occupied" 占用
Unoccupied = "Clear" 出清
Disturbed = "<a href=../Tips/Disturbed.htm>Disturbed</a>, Axles" 计轴干扰
Defect = "<a href=../Tips/Defect.htm>Defect</a>, Axles" 计轴缺点
资源评论
