计算机中央处理器检测工具

CPU-Z 自读文件 ------------------ Version 1.57 版本号 1.57 February 2011 2011年02月 Contact : cpuz@cpuid.com 联系我们 ：cpuz@cpuid.com Web page: http://www.cpuid.com/cpuz.php 网站：http://www.cpuid.com/cpuz.php Validation page : http://valid.canardpc.com 确认页面 ：http://valid.canardpc.com Hall of Fame : http://valid.canardpc.com/records.php 名人堂 :http://valid.canardpc.com/records.php Forum : http://forum.canardpc.com/forumdisplay.php?f=74 社区 ：http://forum.canardpc.com/forumdisplay.php? CPUID SDK : http://www.cpuid-pro.com/devkits.php CPUID SDK介绍 ：http://www.cpuid-pro.com/devkits.php Configuration file (cpuz.ini) 配置文件 (cpuz.ini) ------------------------------ The configuration file must be named cpuz.ini and be present at the same directory level as cpuz.exe. It contains the following : 配置文件必须存放在cpuz.exe. 同一文件夹下名字为cpuz.ini [CPU-Z] TextFontName=Verdana TextFontSize=13 TextFontColor=000060 LabelFontName=Verdana LabelFontSize=13 PCI=1 MaxPCIBus=256 DMI=1 Sensor=1 SMBus=1 Display=1 ShowDutyCycles=0 UseDisplayAPI=1 - TextFontName : Font used for the information boxes. 信息框字体样式 - TextFontSize : Size of the font used for the information boxes. 信息框字体大小 - TextFontColor : Color of the font used for the information boxes. Value is expressed in hexadecimal, and consists in a classic Red/Green/Blue color code : RRGGBB 信息框使用字体颜色。RBG颜色：RRGGBB/000060 - LabelFontName : Font used for the label boxes. 标签框字体样式 - LabelFontSize : Size of the font used for the label boxes. 标签框字体大小 - Sensor : Set to OFF (or 0) disables sensor chip detection and voltages measurement. 1 to enable.传感器检测设置，1为开启、0为关闭 关闭后将不显示温度及电压 - PCI : Set to OFF (or 0) disables the PCI information. This disables chipset, SPD and, depending on the hardware, sensoring information. 1 to enable.PCI检测设置，1为开启、0为关闭 关闭后将不会显示主板、SPD及硬件传感器信息 - MaxPCIBus : Sets the maximum PCI bus to scan. Default value is 256. - DMI : Set to OFF (or 0) disables the DMI (Desktop Management Interface) information. This concerns BIOS vendor and version, motherboard vendor and revision. 1 to enable. DMI设置，1为开启、0为关闭。管壁厚 - SMBus : Set to OFF (or 0) disables SMBus information : SPD, and, depending on the hardware, sensoring information. 1 to enable.SMBUS设置，1为开启、0为关闭 关闭后将不会显示主板、SPD及硬件传感器信息 - Display : Set to OFF (or 0) disables the video card information reported in the validator. 1 to enable. 显示设备设置，1为启开、0为关闭 关闭后将不会显示显示设备信息 - ShowDutyCycles : Set to 1, switches the alternate clock computation method based on duty cycles. 0 to disable.占空比设置，1为开启、0为关闭 关闭后不会进行占空比计算时钟的方法 - UseDisplayAPI : Set to 1, uses the display driver to read the display adapters information. Parameters 参数 ---------- -txt=filename : Launch CPU-Z in ghost mode (no interface appears) and generates the register dump file (.txt) in the same directory as the exe file. 导出报告为txt文本格式 -html=filename : Same as "-txt" except it generates the html report. 导出报告为html超文本格式 -core=id : Displays clock speed of core #id (id can be set from 0 to Number of cores minus one). Keys ---- F5 : save the current tab in a bmp file F5 ：保存当前页面为bmp文件 F6 : save the current tab in the clipboard F6 ：保存当前页面在剪贴板中 F7 : save cvf file in the current directory F7 ：保存CVF在默认目录 Cache Latency Tool ------------------ The cache latency tool can be downloaded at that address : http://www.cpuid.com/medias/files/softwares/misc/latency.zip Cache Latency Tool下载地址 ：http://www.cpuid.com/medias/files/softwares/misc/latency.zip History 更新历史 ------- -------------------------------------------------------------------------------------------------- 1.57 - February 2011 - Intel Xeon "Westmere-EX" support. - GPU frequency report on Intel Sandy Bridge processor. - AMD Zacate/Ontario processors support. - Report TDP on main page when available. - Cores clocks on floating menu. - P67/H67 stepping report. -------------------------------------------------------------------------------------------------- 1.56 - October 2010 - Intel Core i3/i5/i7 "2000" serie processors (Sandy Bridge) with new logos. - Intel Core i7 970 "Gulftown". - Intel P67 chipset. - AMD Phenom II, Athlon II and Sempron II "Caspian" processors. -------------------------------------------------------------------------------------------------- 1.55 - July 2010 - VIA VX900/VX900M and VN1000/VN1000M chipsets. - Intel Core i5-760, Core i7-875K and Core i5-655K processors. - Intel Core i7-940XM, 840QM, 740QM mobile processors. - Intel Core i5-450M, 540UM, 430UM, Core i3-370M mobile processors. - Intel Pentium P6000 processor. - New parameter in cpuz.ini : UseDisplayAPI -------------------------------------------------------------------------------------------------- 1.54 - March 2010 - Intel Core i7-880, Core i5-680, Core i3-550 processors. - Intel Xeon 5600 line (32nm) processors. - AMD Phenom II X6, Sempron II, Turion II, Turion II Ultra and Athlon II Mobile "Caspian" processors. - NVIDIA GeForce 320M chipset. - AMD 870/880G890GX + SB800/SB850 chipset. - Introduction of validation rooms. -------------------------------------------------------------------------------------------------- 1.53 - December 2009 - Fix validation issue with AMD Phenom processors (1.53.1). - Preliminary support for Intel Pinetrail platform (1.53.1). - Intel Core i7 930 & 950, Core i7 980X "Gulftown", Xeon W3565. - Intel Mobile Core i7/i5/i3 "Arrendale" (LV and ULV). - Intel "Clarkdale" platform improved support. - AMD Phenom FX-5000, Athlon II X2/X3/X4, Athlon L110. - AMD AM3 socket detection improved. - VIA VX800 and VX855 chipsets support. - ATI Radeon 2100 and Radeon X1250 support. - DirectX 11 detection fix. - Hardware virtualization support now reported as instructions set. - New HTML report with less information. -------------------------------------------------------------------------------------------------- 1.52 - July 2009 - Fix Core i7 clock bug (1.52.2) - New design with "Graphics" tab. - NVIDIA nForce 980a chipset support. - Intel Core i5 and Core i3 processors. - Intel Atom Z530, Pentium DC E6300 (2.8GHz) and Core 2 Solo processors. - Intel P55 and US15W chipsets preliminary support. - AMD Phenom TWKR support. - AMD Phenom X2 "Callisto" and Athlon X2 "Regor" processors. - AMD Opteron 6-core "Istanbul" processor. - Improved support for Windows 7. - New Intel logos. MD5 checksum : please refer to http://www.cpuid.com/cpuz.php#history -------------------------------------------------------------------------------------------------- 1.51 - April 2009 - New version with installer. - NVIDIA ION platform. - Intel "Clarkdale" processor preliminary support. MD5 checksum : please refer to http://www.cpuid.com/cpuz.php#history -------------------------------------------------------------------------------------------------- 1.50 - February 2009 - Improved support for AMD Phenom II processor. - Support for NVIDIA 740i chipset. - Several bug fixes. MD5 cpuz.exe (1.50) : E1C827C54F527404EDDA6D65DA0280D8 -------------------------------------------------------------------------------------------------- 1.49 - December 2008 - AMD Phenom II processor. - New Intel Core 2 models. - Improved loading time. - New online validation process. MD5 cpuz.exe (1.49) : B836E86B40D7AFAF99D9C512E8CC9FEF -------------------------------------------------------------------------------------------------- 1.48 - October 2008 - Improved support for Intel Core i7 (Bloomfield & Gainestown). - Intel Atom dual-core version support. - AMD Athlon "Kuma" processor support. - Alternate clock computation method based on "duty c